Reducer Oil Drain Plug Bolt Repair Kit for Yamaha Raptor 700 660 Rhino Banshee – Fix Stripped Threads & Leaking Crankcase

Reducer Oil Drain Plug Bolt Repair Kit for Yamaha Raptor 700 660 Rhino Banshee – Fix Stripped Threads & Leaking Crankcase

• Fits - For 2006-2019 Yamaha Raptor 700 (base/R/SE), also fits for Raptor 660, Rhino 660 / 700, and Banshee 350
• Material - Unlike cheap aluminum alternatives, this 316 Stainless Steel bushing provides superior corrosion resistance and holding strength
• Performance - Stop throwing away money on a new crankcase.If your stock 14mm drain plug spins freely or leaks due to minor thread damage, this kit gives your engine a second life
• Installation - Step 1: Tilt the bike back on its rear end and take out the old drain plug Step 2: Apply good mount of grease on Drill bit of 14.5mm thick bit (Not provided with this kit) to catch metal shavings. Step 3: Drill the crankcase hole, then vacuum thoroughly to ensure no shavings remain. Step 4: Use the included tap to cut new threads straight and carefully, clean the threads, and vacuum again. Step 5: Use the red threadlocker (provided) on outer threads of Reducer. Step 6: Tighten reducer to stock specifications and then tighten drain bolt. Step 7: Allow the threadlocker to cure, install the bolt, fill the oil and repair is DONE
• Complete set- This kit contains one oversized 16mm thread repair reducer with with Magnet bolt tip for Raptor 700, one 16mm x 1.5 tap, and thread locker. A 14.5mm drill bit is required but not included (available at any hardware store)